Track-Bed 2' (1) HO ST1461A

Track-Bed 2' (1) HO ST1461A

Brand: Bill and Walt's

FEATURES: Great underlayment for multi-track yards, switches, loading areasand sidings. Quieter operation with sound-deadening material.Smoother operation with vibration-cushioning material.Compatible with cork.Quality material, won't dry out or crumble.This flexible track bed is easier to use.There's no soaking involv ...Read more

  • $ 0.79
  • $ 0.85
  • Save $ 0.06


Description
FEATURES: Great underlayment for multi-track yards, switches, loading areasand sidings.
Quieter operation with sound-deadening material.
Smoother operation with vibration-cushioning material.
Compatible with cork.
Quality material, won't dry out or crumble.
This flexible track bed is easier to use.
There's no soaking involved, just tack or glue down.
Add new levels and realism to your railroad layout economically.
Product conforms to all applicable NMRA standards.

INCLUDES: 1 Pieces of HO Scale Foam Track Bed

REQUIRES: Hobby Knife
Glue or Tacks

SPECS: Scale: HO (1:87)
Length: 24" (60.9cm) -- each piece

Track-Bed Rolls can be laid in one continuous section or cut to fit any area. For tight curves, separate Track-Bed at center seam. Lay both sections separately butting them snugly in the middle. 12" x 24" Track-Bed Super Sheets make great underlayment for multi-track yards, switches, loading areas and sidings.

INSTRUCTIONS: 1. Spread a layer of Foam Tack Glue (ST1444) on the Plaster Cloth surface where the Track-Bed will be laid (Fig. 1).
2. Lay Track-Bed down and pin in place with Foam Nails (ST1432) until glue dries (about 1 hour). Remove nails. Note: To attach Track-Bed to surfaces other than Plaster Cloth, apply Foam Tack Glue to both layout surface and bottom of Track-Bed. Allow glue to become “tacky” (about 5 minutes) and press Track-Bed to surface (Fig. 2). Pin down if necessary.
3. To attach track, spread a layer of Foam Tack Glue over Track-Bed surface and install track, pinning in place with Foam Nails (Fig. 3).
4. Apply Woodland Scenics Ballast according to directions on the package.
TIP: For a more secure adhesion, use 120 grit sandpaper, and sand the top and bottom of the Track-Bed before adhering it to the layout and installing the track.

We Also Recommend