Track-Bed 5mmx5""""x2' (6) HO/O ST1470

Track-Bed 5mmx5""""x2' (6) HO/O ST1470

Brand: Bill and Walt's

FEATURES: Underlayment for multi-track yards, switches, loading areas and sidings.For quieter operation with sound-deadening material.Smoother operation with vibration-cushioning material.Compatible with cork.Quality material, won't dry out or crumble.This flexible track bed is easier to use.Just tack or glue down.Conf ...Read more

  • $ 16.19
  • $ 18.00
  • Save $ 1.81


Description
FEATURES: Underlayment for multi-track yards, switches, loading areas and sidings.
For quieter operation with sound-deadening material.
Smoother operation with vibration-cushioning material.
Compatible with cork.
Quality material, won't dry out or crumble.
This flexible track bed is easier to use.
Just tack or glue down.
Conforms to all applicable NMRA standards.

INCLUDES: Six Pieces of HO/O Scale Foam Track Bed
REQUIRES: Hobby Knife
Glue or Tacks

SPECS: Scale:  HO / O (1:87 / 1:48)
Size: 5mm x 5" x 24" (each)

Track-Bed Rolls can be laid in one continuous section or cut to fit any area. For tight curves, separate Track-Bed at center seam. Lay both sections separately butting them snugly in the middle. 12" x 24" Track-Bed Super Sheets make great underlayment for multi-track yards, switches, loading areas and sidings.

INSTRUCTIONS: 1. Spread a layer of Foam Tack Glue (ST1444) on the Plaster Cloth surface where the Track-Bed will be laid (Fig. 1).
2. Lay Track-Bed down and pin in place with Foam Nails (ST1432) until glue dries (about 1 hour). Remove nails. Note: To attach Track-Bed to surfaces other than Plaster Cloth, apply Foam Tack Glue to both layout surface and bottom of Track-Bed. Allow glue to become “tacky” (about 5 minutes) and press Track-Bed to surface (Fig. 2). Pin down if necessary.
3. To attach track, spread a layer of Foam Tack Glue over Track-Bed surface and install track, pinning in place with Foam Nails (Fig. 3).
4. Apply Woodland Scenics Ballast according to directions on the package.
TIP: For a more secure adhesion, use 120 grit sandpaper, and sand the top and bottom of the Track-Bed before adhering it to the layout and installing the track.

We Also Recommend